User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
8
1800 Series Handheld RFID Reader Reference Manual
ISSUING COMMANDS VIA USB CONNECTION
USB connection can be used for configuring the Reader and to upload data to host
computer. Below are the procedures to create a USB connection before using RFID
Reader.
USING HYPERTERMINAL
On the host computer:
1) Go to the “Device Manager” on the host computer to confirm the used COM port. For
example below, the USB Virtual COM_CDC - COM3 is being used.
Note: By default the USB Interface type set on 1800 RFID Reader is Virtual COM CDC
(CDC and Silicon USB interfaces available). And users are supposed to install the
corresponding driver on host computer before beginning to use RFID Reader. Refer
to
2.1 USB Interface or 1.3.1.2 Functions used for selecting USB type during
operation.