User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
163
value Meaning
0x00 OK
0x01 Host Mode operation finishes
0x02 Host Mode Inventory/Read/Write/Kill/Lock operation stops due to timeout or
excessive retry count
0x03 Reports the tag is locked in response to the host access command
0x04 End of Transmit in uploading Transmit buffer data or Memory mode data
0xDD Fail to configure the parameter of USB HID via 3610
0xDE Incorrect Bluetooth
®
type
(The parameter of Bluetooth
®
type is not consistent with connected device.)
0xDF Fail to set system time
(Real Time Clock cannot be configured.)
0xED Unsupported UHF command (UHF module firmware needs to be upgraded)
0xEE Conflict in Scan Mode and RFID Function
(Write Tag Memory function is not available in Continuous and Test Modes.)
0xEF RFID Fail
(Unable to configure RFID module upon Q value and Module Power Level
Command configurations.)
0xFA Invalid transmit buffer setting
0xFB The last operation is still running
0xFC Invalid mode (sending Host commands in Normal mode)
0xFD Invalid parameter in the Data field
0xFE Incorrect packet length
0xFF Invalid command or parameters
Appendix IV
STATUS CODE