User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
4
1800 Series Handheld RFID Reader Reference Manual
CHARGING THE BATTERY
New batteries are not fully charged. When you first receive the package, you will need to
charge the battery to full before using the RFID Reader. For RFID Reader, use the
adapter to charger the battery. It takes approximately 4 hours to charge the battery to
full.
1) Install the battery in RFID Reader.
2) Remove the cover to the power jack.
3) Connect the power cord to the power jack.
4) Connect the other end of the power cord to a suitable power outlet.
5) The RFID Reader LED1 will be flashing red during charging. When the charging is
done, the LED1 will flash green. If charging error occurs, the LED1 will turn solid red.
For example, a bad or missing battery.
Note: Battery charging stops when the temperature drops below 0°C or exceeds 40°C. It
is recommended to charge the battery at room temperature (18°C to 25°C) for
optimal performance.