User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
3
Introduction
INSTALLING THE BATTERY
1) This RFID Reader is powered by a rechargeable 2500 mAh Li-ion battery. For
intensive data collection, we suggest it is better to purchase a spare battery for
non-stop operation.
2) Turn the battery latch to unlock position.
3) Remove the battery cover.
4) Insert the battery into the battery compartment so that the metal contacts on the
battery meet with the charging contacts inside the compartment. Make sure that the
battery fits snugly into the compartment.
5) Replace and turn the battery cover until it locks into place.
6) After the battery is charged successfully, press the trigger to power on the RFID
Reader. If you cannot power on the RFID Reader, please check that the battery is
charged and that it has been inserted correctly.
Note: (1) Any improper handling may reduce the battery life.
(2) When the main battery capacity becomes low, you need to charge the battery
as soon as possible or replace it with a charged one. Before replacing the battery,
make sure the power is turned off.