User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
137
Chapter 5
DefinING Output Format
5.2.3 EPC TAG SECTION
The EPC tag section is divided into 5 fields as PC, EPC, CRC, Memory Data and Data
Length. Separators can be defined among fields for clarity. Up to 4 separators can be
specified for this section.
Default Format:
Command:
#@dat_rfseq?\r
Purpose Get the Sequence Setting of EPC Tag Data Section
Response OK,[m],[n],[o],[p],[q]\r
[m]: EPC Tag Data in Field 1 (default: ‘2’ – PC)
[n]: EPC Tag Data in Field 2 (default: ‘3’ – EPC)
[o]: EPC Tag Data in Field 3 (default: ‘1’ – CRC)
[p]: EPC Tag Data in Field 4 (default: ‘4’ – Memory Data)
[q]: EPC Tag Data in Field 5 (default: ‘0’ – Disable)
[m]~[q] Description
‘0’ Disable this Field
‘1’ CRC
‘2’ PC
‘3’ EPC
‘4’ Memory Data
This field only appears when RFID function is set to
“Read Tag Memory”
‘5’ Data Length
ERR,[code]\r
#@dat_rfseq=[m],[n],[o],[p],[q]\r
Purpose Set the Sequence of Each Field in EPC Tag Data Section
Response OK\r
ERR,[code]\r
Example:
Command
#@rf_func? → get RFID function