User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
132
1800 Series Handheld RFID Reader Reference Manual
Purpose Set the Sequences of Field in Time Stamp Section
Response OK\r
[m]: Time Data Type in Field 1. Default = ‘1’
[n]: Time Data Type in Field 2. Default = ‘2’
[o]: Time Data Type in Field 3. Default = ‘3’
[p]: Time Data Type in Field 4. Default = ‘0’
[q]: Time Data Type in Field 5. Default = ‘5’
[r]: Time Data Type in Field 6. Default = ‘6’
[s]: Time Data Type in Field 7. Default = ‘7’
ERR,[code]\r
Example:
Command
#@dat_tseq=1,2,3,0,0,0,0 → set to show year, month and day only
Response (s)
OK
24. 2012-04-12 30003430333130303132303030304221
Command
#@dat_tseq=2,3,1,0,0,0,0 → change the sequences of year, month and day
Response (s)
OK
25. 04-13-2012 30003430333130303132303030304221
Note: If the field is disabled, its following separator will also be ignored.