User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
127
Chapter 5
DefinING Output Format
Example 1:
Sequence 1 : Counter Section
Sequence 2 : Timestamp Section
Sequence 3 : UHF Data Section
Command
#@dat_seq?
→ get output data sequence
default sequence: Counter, Timestamp, UHF data
Response (s)
OK,1,2,3
Example 2:
Sequence 1 : EPC tag Section
Sequence 2 : Disabled
Sequence 3 : Disabled
Command
#@dat_seq=3,0,0 → set to show EPC tag section only
Response (s)
OK
30003430333130303132303030304221
Example 3:
Sequence 1 : Timestamp Section
Sequence 2 : EPC tag Section
Sequence 3 : Disabled
Command
#@dat_seq=2,3,0 → set to show 1. Timestamp and 2. EPC tag
Response (s)
OK
2012-04-16 Mon 00:08 37.08 30003430333130303132303030304221
sequence 1 sequence 2