User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
113
Chapter 4
SCANNING UHF RFID
Ta
g
4.4.3 MULTI-TAG BEEP
In order to differentiate between tags read, the reader will beep in the following
sequence:
Get a new tag: one short beep with high tone denoting that a tag is scanned
successfully. Please refer to
1.5 Beeper.
Get a repeated tag: one short beep with low tone (disabled by default)
Full Tag List: six short beeps, low-mid-high-low-mid-high (enabled by default)
Beeping Status
Enabling the beeper for multi-tag beeping can be set using the following commands.
Command:
#@rf_mtagbeep?\r
Purpose Get Multi-Tag Beeping
Response OK,[m],[n]\r (Default m= ‘0’, n= ‘1’)
[m]: Repeated Tag Beeping
[n]: Tag List Full Beeping
ERR,[code]\r
#@rf_mtagbeep=[m],[n]\r
Purpose Set Multi-Tag Beeping
Request #@rf_mtagbeep=[m],[n]\r
[m]: Repeated Tag Beeping. ‘0’ – Disable, ‘1’ – Enable
[n]: Tag List Full Beeping. ‘0’ – Disable, ‘1’ – Enable
Response OK\r
ERR,[code]\r