User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
111
Chapter 4
SCANNING UHF RFID
Ta
g
Counter
Command:
#@rf_mtagcnt?\r
Purpose Get Multi-Tag Counter Value
Response OK,[m]\r (Default m= ‘128’)
[m]: Multi-Tag Counter value: ‘0’ (disable the counter), ‘1’ ~‘128’
ERR,[code]\r
#@rf_mtagcnt=[m]\r
Purpose Set Multi-Tag Counter
Request #@rf_mtagcnt=[m]\r
[m]: Multi-Tag Counter
Response OK\r
ERR,[code]\r
Multi-Tag List Type
Command:
#@rf_mtaglist?\r
Purpose Get Multi-Tag List Type
Response OK,[m]\r (Default m= ‘0’)
[m]: Multi-Tag List Type
‘0’ – EPC
‘1’ TID
ERR,[code]\r
#@rf_mtaglist=[m]\r
Purpose Set Multi-Tag List Type
Response OK\r
ERR,[code]\r