User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
109
Chapter 4
SCANNING UHF RFID
Ta
g
Example:
Command
#@rf_xepcsb=64 → set filter started from bit 64 of the EPC
Response (s)
OK
Command
#@rf_xepc1=8 → set filter length to 8 bits
Response (s)
OK
Command
#@rf_xepcpt=06 → set filter pattern as 0x06
Response (s)
OK
Command
#@rf_epcfcode=31 → filter works on SSCC-96
Response (s)
OK
Command
#@rf_xepcen=1
Response (s)
OK
Tag1 EPC=3110AFEC2B0BEBC205000000 → accept
Tag2 EPC=3110AFEC2B0BEBC206000000 → reject
Tag3 EPC=3110AFEC2B0BEBC207000000 → accept
Tag4 EPC=3030AFEC2B09C44000000005 → accept. It’s not SSCC-96. Bypass!