User's Manual

91
Chapter 3 Settin
g
Up a WPAN Connection
3.2.3 USB VCOM VIA 3610 CONNECTION
If you want to change the USB VCOM via 3610 interface, use one of the connected RFID
Reader to configure the interface-related settings and it will pass the new settings to
3610, which will then initialize and pass the settings to any other connected devices.
1) Power on RFID Reader
2) Connect RFID Reader to host computer with a USB cable.
3) Enable HyperTerminal on the host computer for issuing commands.
4) Follow
Using HyperTerminal to make a USB connection between the host computer
and RFID Reader.
5) Before using USB VCOM via 3610, you need to install USB VCOM driver. Follow
2.6
USB VCOM and HID via 3610
to connect 3610 to the USB port of host computer. And
then make a connection between RFID Reader and 3610.
6) After the connection between RFID Reader and 3610 is established, configure related
settings as below.
Command
#@bt_aclidx=0 → enter 3610 type configuration
Response (s)
OK
Command
#@bt_aclpr=96 → set to 3610 VCOM
Response (s)
OK
Command
#@bt_aclact → activate the settings
Response (s)
OK
7) After the “#@bt_aclact” command is performed, the connection between RFID Reader
and 3610 will disconnect for a while. Once the connection resumes, the interface of
3610 is updated to Virtual COM.
8) Then 3610 will pass the settings to other connected devices.