User's Manual

Chapter 2

Communication Interface

2.7 USB VCOM VIA 3610

Connect 3610 to the USB port of host computer, and then connect RFID Reader to 3610 via

Bluetooth

. Configure the output interface to USB VCOM via 3610 by issuing the

“#@bt_type=” command to parameter ‘6’. You may run HyperTerminal.exe on the host

computer to view and capture the data transmission from RFID Reader.

Note: As above for a read only interface, you can not issue “#@bt_type=” command to

change the Bluetooth

interface to 3610 directly by command.

How to connect with the 3610?

There are two parameters for “#@bt_target” command to 3610. One is Bluetooth

type and another

is the serial No. of 3610.

Command:

#@bt_target?\r

Purpose Get Bluetooth

Target Machine

Response OK,[m],[n]\r

[m]: Bluetooth

Type, ‘0’ – SPP Master, ‘1’ – 3610

[n]: MACID of target Machine or S/N of 3610

ERR,[code]\r

#@bt_target=[m],[N]\r

Purpose Set Bluetooth

Target Machine

Response OK\r

ERR,[code]\r

Example:

Note: If you are using USB VCOM for the first time, you must install its driver from the

CD-ROM. Driver version 5.4 or later is required. Please remove older versions before

installing new ones!

For a COM Port connection, you have to configure the USB interface type firstly by

“#@usb_type=” command. Wrong USB interface type configured will make disconnection.

Refer to 2.1 USB Interface