User's Manual

37
Chapter 1 Understanding RFID Reader
Note: Power on RFID Reader, the default value for USB Virtual COM driver is CDC. Press
<F1> one time upon command3 to switch to Silicon type if you are using Silicon drive
as a Virtual COM connection. Wrong VCOM type selection will make disconnection.
 Command4:
a. Break the current connection when Bluetooth
®
is connected.
b. Reset the connection type to default – SPP slave when Bluetooth
®
is not connected.
Press <F2> to switch between Command 1, 2, 3 and 4
Command1 Command2 Command3 Command4
Note: Except for function keys, you can also issue command to break or reset the
Bluetooth
®
connection. Refer to 3.3.1 Break a Connection and 3.3.2 Reset a
Connection.
1.4.3 BLUETOOTH
®
PAIRING MODE
For Bluetooth
®
connection or numeric input required situations; you have to combine
Function key and <Trigger> to input numeric code. Refer to 1.3 Function Key
.
Various numeric input will show you different LED status illustrated below:
No.1~5 No.6~0