User's Manual

34
1800 Series Handheld RFID Reader Reference Manual
GOOD READ LED STATUS
You may configure the LED3 status for a feedback about good read.
Command:
#@sys_leden?\r
Purpose Get Good Read LED Status
Response OK,[m]\r (Default m= ‘1’)
[m]: ‘0’ – Disable
‘1’ – Enable
ERR,[code]\r
#@sys_leden=[m]\r
Purpose Set LED Good Read Status
Response OK\r
ERR,[code]\r
GOOD READ LED DURATION
For a good read for LED3, you may configure the duration time.
Command:
#@sys_leddu?\r
Purpose Get Good Read LED Duration
Response OK,[m]\r (Default m= ‘4’)
[m]: Duration=‘1’ ~ ‘254’
ERR,[code]\r
#@sys_leddu=[m]\r
Purpose Set LED Duration
Response OK\r
ERR,[code]\r
1.4.2 TEMPORARY MODE
In this mode, combine with five LEDs and function keys, the LED status can be classified
into 3 Groups that are described below, also refer to 1.3 Function Key
.