User's Manual

33
Chapter 1 Understanding RFID Reader
1.4 LED INDICATORS
The five LEDs on the RFID Reader are used to provide a feedback to user about the behavior
comes from RFID Reader. For example, the LED1 becomes solid red and goes off upon
powering on.
The LED indicators status can be divided into 3 parts ─ Normal, Temporary Status and
Bluetooth
®
Pairing Modes.
1.4.1 NORMAL MODE
Normal mode shows you the normal LED status without any advanced configuration.
LED
Color Status Description
LED1-Power Red On-Off Power on, with one long beeps (high tone,
LED1 on for 1 second and then off.)
Red On
 Charging Fail
 Power Off (Press F1+F2 to power off
simultaneously, until both of the function
keys are released)
Red Flashing Charging (On/Off ratio 0.5s:0.5s)
Green Flashing Charging Done (On/Off ratio 0.5s:0.5s)
LED2-Bluetooth
®
Communication
Blue Flashing On/Off ratio 0.5s:0.5s for two minutes
indicates the RFID Reader is waiting for
connection, and goes off if no connection is
established.
On/Off ratio 0.1s:0.1s indicates the RFID
Reader receives a PIN code request from host
(flashing more quickly than waiting
connection)
On/Off ratio 0.02s:3s indicates the RFID
Reader has established a Bluetooth
®
connection successfully.
LED3-RFID Tag Access Green On-Off Good Read/Write with one short beeps (high
tone). The pitch and duration are
programmable.
LED4-Data
Transmission
Green Flashing Indicate the data is transmitted between
RFID Reader and host. The speed of flashing
varies with data rate.
LED5-Memory Status Green Flashing Flashing ((On/Off ratio 0.02s:3s) indicates
Free memory size > 10%
** Only for memory mode
Red Flashing Flashing (On/Off ratio 0.02s:3s) indicates
memory under 10%
** Only for memory mode
Note: You can configure the good read LED3 status (disable/enable) and duration (ranging
from 1 to 254 in units of 10 milliseconds) by command. When you set the LED3
feedback as disable, the LED3 will always off for each good read.