User's Manual

1800 Series Handheld RFID Reader Reference Manual

Command:

#@sys_memdly?\r

Purpose Get Data Transmission Delay

Response

OK,[m]\r (Default m= ‘0’)

[m]: ‘0’~’7’

Data Transmission Delay

Value Delay

‘0’ 0 ms

‘1’ 250 ms

‘2’ 500 ms

‘3’ 1 sec

‘4’ 2 sec

‘5’ 3 sec

‘6’ 5 sec

‘7’ 8 sec

ERR,[code]\r

#@sys_memdly=[m]\r

Purpose Set Data Transmission Delay

Response OK\r

ERR,[code]\r

SEND DATA

The RFID Reader will respond with two short beeps (high-low tone) as a warning when sending data.

You are advised to send data to the host computer immediately by issuing “#@sys_memup”

command. The RFID Reader will restore the previous connection with the host computer temporarily

so that you can transmit data to the host computer.

Command: