User's Manual

Quick Start

ISSUING COMMANDS VIA USB CONNECTION

USB connection can be used for issuing commands and upload data to host computer.

Below are the procedures to create a USB connection before using RFID Reader.

USING HYPERTERMINAL

On the host computer:

1) Go to the “Device Manager” on the host computer to confirm used COM port. For

example below, the USB Virtual COM_CDC - COM3 is used.

Note: For USB Interface type, the default value is VCOM CDC. Refer to 2.1 USB Interface

Function Key used for selecting USB type during operation. Before beginning to use

RFID Reader, you have to install the available driver on the host computer firstly. The

USB virtual COM driver (CDC or Silicon) between RFID Reader and host computer

must be the same.

2) Use a test application to confirm the connection between host computer and RFID

Reader. E.g. HyperTerminal. Open the HyperTerminal on the host computer.

3) Enter a name and choose an icon for the connection. Click “OK” to continue.