User's Manual

2
1800 Series Handheld RFID Reader Reference Manual
4) Shut the battery cover back to the RFID Reader until it clicks into place.
5) If the battery is charged successfully, press the <Trigger>, RFID Reader will be powered
on. If you can not power on the RFID Reader, maybe one of the issues comes from
battery. Then charge the battery to full. It may take approximately 4 hours to charge the
battery to full capacity.
Note: (1) Any improper handling may reduce the battery life.
(2) When the main battery charge becomes low, you need to charge the battery as
soon as possible or replace it with a charged one. While replacing the battery, make
sure the power is turned off.
CHARGING THE BATTERY FOR RFID READER
The battery may not be charged to full for shipment. When you first receive the package,
you will need to charge the battery to full before using the RFID Reader. For RFID Reader,
use the adapter to charger the battery. It takes approximately 3 hours to charge the battery
to full.
1) Install the battery to RFID Reader.
2) Remove the power cover.
3) Connect the power cord to the power jack.
4) Connect the other end of the power cord to a suitable power outlet.
5) The RFID Reader LED1 will be flashing red during charging. When the charging is done,
the LED1 will turn off. When charging error occurs, the LED1 will turn solid red. For
example, a bad or missing battery.