User's Manual

119
Chapter 5 RFID Scan
Response
OK,[m]\r (Default m= ‘6’)
[m]: Scan Mode
‘6’ – Single Mode
‘7’ – Test Mode
‘9’ – Multi – Tag Mode
ERR,[code]\r
#@rf_scan=[m]\r
Purpose Set Scan Mode
Response OK\r
ERR,[code]\r
5.2 SCAN TIME
5.2.1 TIMEOUT
You have to specify the scanning timeout interval (0~254 sec.; 0= Disable) when the scan
mode is set to Single Mode.
 Operation will stop if the operation time = Scan Session Timeout and No Tag data is
received.
 The range of timeout is 0~254 second. When the timeout is set to ‘0’, the operation will
not stop.
Command:
#@rf_tscan?\r
Purpose Get Scan Session Timeout
Response OK,[m]\r (Default m= ‘0’)