User's Manual

90
1800 Series Handheld RFID Reader Reference Manual
3.2.2 USB VCOM VIA 3610 CONNECTION
If you want to change the USB VCOM via 3610 interface, use one of the connected RFID
Reader to configure the interface-related settings and it will pass the new settings to 3610,
which will then initialize and pass the settings to any other connected devices.
1) Power on RFID Reader
2) Connect RFID Reader to host computer with a USB cable.
3) Enable HyperTerminal on the host computer for issuing commands.
4) Follow Using HyperTerminal
to make a USB connection between the host computer and
RFID Reader for changing Bluetooth
®
type to 3610.
5) Within two minutes, follow 2.6 USB HID via 3610
to connect 3610 to the USB port of
host computer. For USB VCOM, you need to install its driver first! Refer to 2.1 USB
Interface.
6) Configure related settings as below.