User's Manual

88
1800 Series Handheld RFID Reader Reference Manual
Note: When any changes are made to authentication and PIN code on the RFID Reader, or
you want to change to use Bluetooth
®
HID, it is suggested to remove the connected
RFID Reader from the paired device list (called unpairing) firstly and go through the
whole process to re-establish the connection.
10) Run the desired application on host computer, such as HyperTerminal.exe if using Bluetooth
®
SPP or Notepad.exe if using Bluetooth
®
HID.
Once the desired application is configured completely, the status of the RFID Reader listed on
the device list will be showed as “Connected”, indicating the WPAN connection is established
successfully.
3.2 CONNECTING VIA 3610
Before 3610 connection, you have to configure the pre-processing about 3610 relative
configurations by issuing command firstly. Refer to 2.6 USB HID via 3610
or 2.7 USB VCOM
via 3610
.
Note: If you are using USB VCOM for the first time, you must install its driver from the
CD-ROM. Driver version 5.4 or later is required. Please remove older versions! Refer
to 2.1 USB Interface
.