Product Info

1662/1664 Barcode Scanner User Guide
The example below shows how to set string parameters:
Steps Action Scanner Feedback if Successful
1) Power on the scanner... The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off.
2) Enter the Configuration Mode… The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
3) Read a Setup barcode...
For example,
4) Exit the Configuration Mode…
OR
The scanner will respond with one short
beep if reading a special setup barcode
such as “Prefix Code”, indicating the setup
requires reading more barcodes.
When “Bluetooth
®
HID” or “USB HID” is
configured for interface, Key Type and Key
Status will then become applicable. You
may decide whether or not to change key
status when “Normal Key” is selected for
Key Type.
 Refer to Appendix III
Read the “Hexadecimal Value” barcodes
for the desired character string. For
example, read “2” and “B” for the scanner
to prefix the character “+”.
 Refer to Appendix IV “Hexadecimal
System”
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
Same as for Enter the Configuration Mode.
5) The scanner will automatically restart itself… Same as for Power on the scanner.
16
Enter Setup
Special setup
barcodes
Hexadecimal
barcodes