User Manual

44
Enter Setup
1664 Barcode Scanner User Guide
1.14 PICKLIST MODE
Picklist mode enables the decoder to decode only the barcodes aligned under the center
of the laser aiming pattern.
Enable
*Disable
1.15 PAGER BEEP DURATION
Paging function is only activated when 1664 is in Power-Saving mode. 1664 can be
waked up via receiving any Bluetooth signal or press any specific key upon Bluetooth
connection. The buzzer will make two short beeps with high tone when the pager beep
duration setting time is up for each time, then stop to beep until next Power-Saving time
out is reached or power key is pressed.
By default, the pager beep duration is 5 seconds. Specify a value, ranging from 0 to 15.
(0~15 sec.; 0= Disable)
 Bluetooth HID profile: Press any key among “Scroll Lock”, “Number Lock” or “Caps
Lock” on the host computer to trigger the waking up of 1664.
 Bluetooth SPP Profile: Any signal sent from serial port will trigger the waking up of
1664.
Pager Beep Duration
0
~15 sec.
(*5 s)
1) Read the barcode above to specify the activated reminding time interval.
2) Read the “Decimal Value
” barcode on page 251. For example, read “1” and “5” for the
pager beep function to be activated each 15 seconds after entering Power-Saving
mode.
3) Read the “Validate” barcode on the same page to complete this setting.