User Manual

12
Enter Setup
1664 Barcode Scanner User Guide
DEFAULT SETTINGS
SAVE USER SETTINGS AS DEFAULTS
For the scanner to keep the customized settings as user defaults, you must have it read
the “Save as User Defaults” barcode. This is a normal setup barcode, and the scanner will
respond with two beeps (low-high tone).
 After reading the “Update” barcode, the current settings will be saved as user
defaults.
S
ave as User
Defaults
RESTORE USER DEFAULTS
For the scanner to restore the user defaults, which you have saved earlier, you must
have it read the “Restore User Defaults” barcode. This is a normal setup barcode, and the
scanner will respond with two beeps (low-high tone).
 After reading the “Update” barcode, all the parameters of the scanner will return to
their customized values.
Restore User
Defaults
RESTORE SYSTEM DEFAULTS
For the scanner to restore the factory defaults, have it read the “Restore System
Defaults” barcode. This is a normal setup barcode, and the scanner will respond with two
beeps (low-high tone). After reading the “Update” barcode, all the parameters of the
scanner will return to their default values. The current connection record will be cleared
as well. Refer to 1.18.1 Restore System Defaults
for the key combination used to restore
defaults during operation.
For 3610 to restore factory defaults, refer to 3610 Setup Barcodes
& Serial Commands.
Restore System
Defaults
Note: The system default value (if there is) for each setting is indicated by an asterisk
“*”.