User's Manual

9
Update
The configuration of the scanner can be done by reading the setup barcodes contained in
this manual or via the ScanMaster software.
This section describes the proce dure of co nfiguring the scanner by reading the setup
barcodes and provides some examples for demonstration.
Configuration Mode
1) Hold down the [Power/Delete] key for 2 seconds to turn on the scanner. It will respond with a
long beep and its LED will come on-off.
2) Read the “Enter Setup” barcode. It will respond with six beeps and i ts LED i ndicator will
become flashing red after reading the barcode.
3) Read more setup barcodes… Most of t he setup barcodes are normal, and the scanner will
respond with two beeps (low-hi gh tone). For special setup barcodes, it requires reading more
than one setup barcode to complete the setting.
4) Read the “Update” or “Abort” barcode. It will respond with six beeps and its LED indicator will
become flashing red after reading the barcode.
5) The scanner will restart automati cally upon reading the “Update ” or “Abort” barcode. It will
respond with a long beep and its LED will come on-off.
Note: Refer to Appendix II Host Serial Commands for how to configure the 3610 dongle
by having the sca nner read 3610-relate d setup barcodes or using ser ial
commands.
QUICK START