User Manual

49
Update
In order to establish a proper connection between your computer and the scanner, we
suggest that you follow these instructions –
1) Install batteries and hold down the [Power/Delete] key for about 2 seconds to turn on
the scanner.
2) Have the scanner read the “Enter Setup” barcode to enter the configuration mode.
3) Have the scanner read the associated barcodes to activate the desired interface.
See the following sections for output interfaces supported.
4) Have the scanner read the barcodes for related settings.
5) Have the scanner read the “Update” barcode to exit the configuration mode.
6) Turn on your computer or laptop and establish a WPAN connection with the scanner.
Refer to
Chapter 3 – Setting up a WPAN Connection.
Note: By default, the output interface is set to “BT HID”.
IN THIS CHAPTER
2.1 BT HID ...................................................................... 50
2.2 BT SPP Slave .............................................................. 61
2.3 BT SPP Master ............................................................ 63
2.4 USB HID via 3610 ....................................................... 67
2.5 USB Virtual COM via 3610 ............................................ 76
Chapter 2
SELECTING OUTPUT INTERFACE