User Manual

25
Update
Chapter 1
Auto Off after
0~254 min. (*10)
1) Read the barcode above to specify the time interval before the scanner automatically
turns off.
2) Read the “
Decimal Value” barcode on page 錯誤! 尚未定義書籤。. For example, read “1”
and “5” for the scanner to automatically turn off after being idle for 15 minutes.
3) Read the “Validate” barcode on the same page to complete this setting.
Note: Auto Power Off will not take effect when the scanner is in the configuration mode.
Power-Sav
ing after
0~254 min. (*2)
1) Read the barcode above to specify the time interval before the scanner enters
low-speed mode.
2) Read the “
Decimal Value” barcode on page 錯誤! 尚未定義書籤。. For example, read “5”
for the scanner to enter low-speed mode after being idle for 5 minutes.
3) Read the “Validate” barcode on the same page to complete this setting.
Note: Power-Saving will not take effect when one of the following conditions is met:
(1) the scanner has already established a BT HID/SPP connection,
(2) the scanner is in the configuration mode,
(3) the scan mode is set to Test, Continuous or Alternate Mode, or
(4) the setting value of Power-Saving is greater than that of Auto Power Off.