User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
22
Enter Setup
1660 Barcode Scanner User Guide
Delete the last collected data when in memory mode …
Press the [Power/Delete] key. The scanner will respond with two short beeps (high tone) and the
LED will become solid red. Before the LED goes off (within 1 second), press the [Power/Delete] key
again to confirm the deletion.
Note: For the scanner to restore system defaults during operation, use key combination
in the following sequence: Hold down the [Power/Delete] key until its LED
indicator becomes solid red, and without releasing the key, you must press the
[Trigger] key simultaneously for 3 seconds. Then, the scanner will respond with a
long beep (high tone), and the indicator will go off.