User Manual

15
Update
錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。
The example below shows how to set numeric parameters:
Steps Action User Feedback if Successful
1 Power on the scanner...
The scanner will respond with a long beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
2 Enter the Configuration Mode… The scanner will respond
with six beeps
(high-
low tone repeats three times), and
its LED indicator will become flashing red.
3 Read a Setup barcode...
For example,
The scanner will respond with two beeps
(low-high tone) if reading a
normal setup
barcode.
The scanner will respond with one short
beep if reading a special setup barcode
such as “Max. Length”, indicating the
setup requires reading more barcodes.
Read the “Decimal Value” barcode(s).
 Refer to Appendix IV “Decimal
System”
The scanner will r
espond with two beeps
(low-high tone) when the input values are
validated.
4 Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
5 The scanner will automatically restart itself… Same as for Power on the scanner.
Normal setup
barcode
Special setup
barcode
Decimal barcodes
Normal setup
barcode