User's Manual

Update

In order to establish a proper connection between your computer and the scanner, we

suggest that you follow these instructions –

1) Install batteries and press the [Delete] key for 3 seconds to turn on the scanner.

2) Have the scanner read the “Enter Setup” label to enter the configuration mode.

3) Have the scanner read the associated label to activate the desired interface.

See the following sections for output interfaces supported.

4) Have the scanner read the labels for related settings.

5) Have the scanner read the “Update” label to exit the configuration mode.

Note: By default, the output interface is set to “Bluetooth HID”.

IN THIS CHAPTER

2.1 Bluetooth HID ........................................................... 31

2.2 Bluetooth SPP ........................................................... 38

2.1 BLUETOOTH HID

Refer to Chapter 3 – Setting up Bluetooth Connections for related settings.

Bluetooth HID Settings

Defaults

Keyboard Type PCAT (US)

Digits Layout Normal

Capital Lock Type Normal

Capital Lock State Off

Alphabets Transmission Case-sensitive

Digits Transmission Alphanumeric keypad

Inter-Function Delay 0 (ms)

Send “NR” to Host Disable

Chapter 2

SELECTING OUTPUT INTERFACE