User's Manual

12
Enter Setup
1600 Series Barcode Scanner User Guide
5) Replace the battery lid and lock it firmly.
1.1.2 HOW TO OPERATE THE SCANNER
 To turn on the scanner, press the [Delete] key for 3 seconds, and the scanner will
respond with a long beep (high tone).
 To turn off the scanner, press the [Delete] key for 1.5 seconds. The scanner will
respond with short beep (high tone) and the LED will become solid green, then go off,
and finally become solid red. Release the key then.
 To delete the last collected data, press the [Delete] key. The scanner will respond
with short beep (high tone) and the LED will become solid green. Before the LED goes
off (within 1 second), press the [Delete] key again to confirm the deletion.
1.1.3 AUTO POWER OFF
Specify the time interval (1~254 min.; 0= disable) for the scanner to wait for a computer
to establish a connection via a Bluetooth dongle. By default, the 1660 scanner will stay
active for 10 minutes waiting for a connection request. If it fails to connect within the
time interval, the scanner will automatically turn off in order to conserve battery power
(you will hear three short beeps, tone descending from high to low). Press the [Delete]
key for 3 seconds to turn it on. On your computer, you will have to search Bluetooth
devices again.
Once a Bluetooth connection is established successfully, the scanner will stay active as
long as the COM port is opened by a host application.
1) Read the label above to specify the time interval before the scanner automatically
turns off.
2) Read the “Decimal Value
” label on page 123. For example, read “1” and “5” for the
scanner to automatically turn off after being idle for 15 minutes.
3) Read the “Validate” label on the same page to complete this setting.
Auto Off after 0~254 minutes (*10)