User's Manual

8
1600 Series Barcode Scanner User Guide
CHARACTER STRING PARAMETERS
Steps Action User Feedback if Successful
1 Power on the scanner... The scanner will respond with a long beep
(high tone).
2 Enter the Configuration Mode…
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
Read a Setup label...
For example,
The scanner will respond with one short
beep if reading a special label such as
“Prefix Code”, indicating the setup
requires reading more labels.
When “Keyboard Wedge” is configured for
interface, Key Type and Key Status will
then become applicable.
 You may decide whether or not to
apply Key Status when “Normal Key”
is selected for Key Type.
3
Read the “Hexadecimal Value” label for
the desired character string. For example,
read “2” and “B” for the scanner to prefix
the character “+”.
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
4 Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
S
p
ecial label
Hexadecimal
labels