User's Manual

135
Update
SERIAL COMMANDS
#@NNNNNN<CR>
Purpose To configure the scanner.
Remarks nnnnnn – the six digits of command parameters. For example, “109952” is to list the
current Code ID settings.
“0x23” + “0x40” + “0x31” + “0x30” + “0x39” + “0x39” + “0x35” + “0x32” + “0x0d”
#@ - - - -<CR>
Purpose To halt the scanner.
Remarks “0x23” + “0x40” + “0x2d” + “0x2d” + “0x2d” + “0x2d” + “0x0d”
#@ . . . . <CR>
Purpose To resume operation.
Remarks “0x23” + “0x40” + “0x2e” + “0x2e” + “0x2e” + “0x2e” + “0x0d”
#@////<CR>
Purpose To respond with a beep.
Remarks “0x23” + “0x40” + “0x2f” + “0x2f” + “0x2f” + “0x2f” + “0x0d”
#@TRIGOFF<CR>
Purpose Disable software trigger
Remarks “0x23” + “0x40” + “0x54” + “0x52” + “0x49” + “0x47” + “0x4f” ” + “0x46” ” +
“0x46” + “0x0d”
#@TRIGON<CR>
Purpose Enable software trigger
Remarks “0x23” + “0x40” + “0x54” + “0x52” + “0x49” + “0x47” + “0x4f” ” + “0x4e” ” +
“0x0d”
Appendix III
HOST SERIAL COMMANDS
Serial Command
List Page 3