User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
64
Enter Setup
1564 Barcode Scanner User Guide
1.15.3 SIGNATURE CAPTURE WIDTH & HEIGHT
The aspect ratio of the Signature Capture Width and Signature Capture Height
parameters must match that of the signature capture area. For example, a 4 x 1 inch
signature capture area would require a 4 to 1 aspect ratio of width to height.
Signature Capture
Width 1~752 (*400)
Signature Capture
Height 1~480 (*100)
1) Read the barcode above one at a time to specify its value.
2) Read the “
Decimal Value” barcode on page 錯誤! 尚未定義書籤。. For example, read “4”,
“8” and “0” for a value of 480.
3) Read the “Validate” barcode on the same page to complete this setting.
1.15.4 SIGNATURE CAPTURE JPEG QUALITY
Specify the JPEG quality value. By default, it is set to 65.
JPEG Quality Value
5~100 (*65)
1) Read the barcode above to specify a value.
2) Read the “
Decimal Value” barcode on page 錯誤! 尚未定義書籤。. For example, read “5”
and “0” for a value of 50.
3) Read the “Validate” barcode on the same page to complete this setting.