User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
61
Update
Chapter 1
1.14.6 JPEG IMAGE OPTIONS
Optimize JPEG images for either size or quality.
*JPEG Quality
Selector
JPEG Size Selector
JPEG Target File Size
Define the target JPEG file size in terms of 1 Kilobytes (1024 bytes). By default, it is set to 40
Kilobytes.
JPEG Target File Size
5~150 (*40)
1. Read the barcode above to specify a value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “1”, “2” and
“0” for a value of 120.
3. Read the “Validate” barcode on the same page to complete this setting
JPEG Quality Value
If you selected JPEG Quality Selector, specify the JPEG quality value. By default, it is set to 65.
JPEG Quality Value
5~100 (*65)
1. Read the barcode above to specify a value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “5” and “0”
for a value of 50.
3. Read the “Validate” barcode on the same page to complete this setting