User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
59
Update
Chapter 1
1.14.3 IMAGE CROPPING
This is used to crop a captured image.
Disable Image Cropping: Present the full 1280 x 1024 pixels.
Enable Image Cropping: Crop the image to the pixel addresses specified.
Enable
*Disable
Note: The scanner has a cropping resolution of 4 pixels. Setting the cropping area to less
than 3 pixels transfers the entire image.
Crop to Pixel Address
For image cropping, set the pixel addresses from (0,0) to (751, 479) to crop to. Columns are
numbered from 0 to 751, rows from 0 to 479
. Specify four values for Top, Left, Bottom, and Right,
where Top and Bottom correspond to row pixel addresses, and Left and Right correspond to column
pixel addresses. For example, for a 4 row x 8 column image in the extreme bottom-right section of
the image, set the following values:
Top = 476, Bottom = 479, Left = 744, Right = 751
Top (0~479)
Left (0~751)
Bottom (0~479)
Right (0~751)
1. Read the barcode above one at a time to specify its value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “4”, “7” and
“6” for a value of 476.
3. Read the “Validate” barcode on the same page to complete this setting