User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
56
Enter Setup
1564 Barcode Scanner User Guide
1.13.4 ENTER/EXIT VIDEO MODE
Read the barcode below to temporarily enter this mode.
Video Mode
Enter Video Mode
Have the scanner read the setup barcodes in a separate but complete sequence:
Exit Video Mode
In Video Mode, the decoder behaves as a video camera as long as the trigger is active. When you
release the trigger, the decoder returns to Decode Mode.
1.13.5 VIDEO MODE SETTINGS
Target Video Frame Size
Select the number of 100-byte blocks to transmit per second. Values range from 800 to 20000
bytes. Selecting a smaller value transmits more frames per second but reduces video quality;
selecting a larger value increases video quality but slows transmission.
Target Video Frame
Size in 100 bytes
8~200 (*22)
1. Read the barcode above to specify a value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “2” and “0”
for setting the video frame size to 2000 bytes.
3. Read the “Validate” barcode on the same page to complete this setting