User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
55
Update
Chapter 1
Image Brightness (Target White)
Decide whether to set the Ta
rget White value when using autoexposure. White and black are
defined as 255 decimal and 0, respectively. If the value is 180, which is the factory default, the
white level of the image is ~180.
Image Brightness
1~240 (*180)
1. Read the barcode above to specify a value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “1”, “2” and
“0” for a value of 120.
3. Read the “Validate” barcode on the same page to complete this setting