User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
54
Enter Setup
1564 Barcode Scanner User Guide
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “1” and “5”
for setting the preview image size to 1500 bytes.
3. Read the “Validate” barcode on the same page to complete this setting.
Image Capture Illumination
Decide whether to cause the decoder to flash illumination on every image capture to aid decoding.
Enabling illumination usually results in superior images. The effectiveness of the illumination
decreases as the distance to the target increases.
*Enable
Disable
Image Capture Autoexposure
Decide whether to manually specify the gain and exposure time (only recommended for advanced
users with difficult image capture situations).
*Enable
Disable
By default, exposure value is set to 1 ms and gain value is set to 10
0 when autoexposure is
disabled.
Fixed Exposure
in 100
μ s
2~5000 (*10)
1. Read the barcode above to specify a fixed exposure value.
2.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “1” and “5”
for setting the exposure value to 1.5 ms.
3. Read the “Validate” barcode on the same page to complete this setting
Fixed Gain
1~100 (*100)
4. Read the barcode above to specify a fixed gain value.
5.
Read the “
Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “3” and “0”
for setting the gain value to 30.
6. Read the “Validate” barcode on the same page to complete this setting.