User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
53
Update
Chapter 1
1.13.3 IMAGE MODE SETTINGS
Image Mode Timeout
Set the amount of time the decoder remains in Image Mode. The decoder exits Image Mode upon a
trigger event, or when the Image Mode Timeout elapses. By default, the time-out value is set to 0
which represents 30 seconds. Values increment by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Image Mode Time-out
after 30~ sec.
(*0)
1. Read the barcode above to specify the time interval before returning to Decode Mode. (It is
set to 0 by default.)
2.
Read the “Decimal Value” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “5” for the
scanner to automatically shut down after being idle for 180 seconds.
3. Read the “Validate” barcode on the same page to complete this setting.
Image Aiming Pattern
Decide whether to allow the decoder to project the aiming pattern in Image Mode.
*Enable
Disable
Video View Finder
Decide whether to enable Image Mode with View Finder, which the decoder behaves as a video
camera until a trigger event is activated.
Enable
*Disable
Select the number of 100-byte blocks. Values range from 800 to 12000 bytes. Selecting a smaller
value transmits more frames per second; selecting a larger value increases video quality.
Video View Finder
Image Size in 100
bytes 8~120 (*17)
1. Read the barcode above to specify a value.