User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
52
Enter Setup
1564 Barcode Scanner User Guide
1.13.2 ENTER/EXIT IMAGE MODE
Use Image Mode to capture a high-quality image and transmit it to the host. Read the
barcode below to temporarily enter this mode.
Image Mode
Enter Image Mode
Have the scanner read the setup barcodes in a separate but complete sequence:
Exit Image Mode
Once the software application finishes the task of receiving an image, the scanner returns to
Decode Mode.
If a trigger event is not activated within the Image Mode Timeout period, the decoder returns
to Decode Mode.