User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
50
Enter Setup
1564 Barcode Scanner User Guide
1.13.1 DECODE MODE SETTINGS
By default, this is the normal operation mode. The decoder attempts to locate and
decode any barcode within its field of view upon a trigger event. Refer to
1.6 Scan
Modes.
Decode Aiming Pattern
Decide whether to allow the decoder to project the aiming pattern during a barcode capture.
*Enable
Disable
Decoding Illumination
Decide whether to cause the decoder to flash illumination on every image capture to aid decoding.
Enabling illumination usually results in superior images. The effect
iveness of the illumination
decreases as the distance to the target increases.
*Enable
Disable
Decoding Autoexposure
Decide whether to manually specify the gain and exposure time (only recommended for advanced
users with difficult image capture situations).
*Enable
Disable
By default, exposure value is set to 1 ms and gain value is set to 10
0 when autoexposure is
disabled.
Fixed Exposure
in 100
μ s
2~5000 (*10)