User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
19
Update
LIST THE CURRENT SETTINGS
The current settings of all scanner parameters can be sent to the host computer for user
inspection. The listing includes pages as shown below. You can select the page of interest
by having the scanner read the “List Page x” barcode. The scanner will respond with two
beeps (low-high tone) and send the selected page to the host immediately.
List settings regarding Firmware Version, Serial
Number, Interface, Buzzer, and Other Scanner
Parameters
List Page 1
List settings regarding Prefix, Suffix, and Length
Code Setting (1/2)
List Page 2
List settings regarding Prefix, Suffix, and Length
Code Setting (2/2)
List Page 3
List settings regarding Code ID
List Page 4
List settings regarding: Readable Symbologies
(1/2)
List Page 5
List settings regarding: Readable Symbologies
(2/2)
List Page 6
List setti
ngs regarding Symbology Parameters
(1/3)
List Page 7
List settings r
egarding Symbology Parameters
(2/3)
List Page 8
List settings regarding Symbology Parameters
(3/3)
List Page 9
List settings regarding Imager Parameters, as
well as Video and Signature Capture Parameters
List Page 10