User Manual
Table Of Contents
- Important Notices
- Release Notes
- Introduction
- Quick Start
- Understanding the Barcode Scanner
- 1.1 Battery
- 1.2 Memory
- 1.3 LED Indicator
- 1.4 Beeper
- 1.5 Send “NR” to Host
- 1.6 Scan Modes
- 1.7 Scanning Timeout
- 1.8 Delay between Re-read
- 1.9 Read Redundancy (1D)
- 1.10 Addon Security for UPC/EAN Barcodes
- 1.11 Effective Decoding Area
- 1.12 Negative Barcodes
- 1.13 Operation Mode
- 1.14 Imager Preferences
- 1.15 Signature Capture
- Selecting Output Interface
- Setting up a WPAN Connection
- Specifications
16
Enter Setup
1564 Barcode Scanner User Guide
The example below shows how to save your settings as “User Default” so that you may
restore user defaults at a later time:
Steps Action User Feedback if Successful
1 Power on the scanner…
The scanner will respond with a long beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
2 Enter the Configuration Mode…
The scanner will respond with six beeps
(high-low tone repeats three times)
, and
its LED indicator will be flashing red.
3 Read a Setup barcode…
For example,
The scanner w
ill respond with two beeps
(low-high tone) if reading a
normal setup
barcode.
4 Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
5 The scanner will automatically restart itself… Same as for Power on the scanner.
* When any configuration error occurs...
The scanner will respond with one long
beep (low tone).