User manual

BEEPER
The scanner has a buzzer to provide user feedback in various operating conditions.
BEEPING MEANING
One long beep, high tone. Power on, with red LED on and off quickly.
One short beep, high tone.
• Programmable, default to 4 kHz
Good read, with green LED on and off quickly.
Six short beeps
• High – low tone repeats three times.
• Enter configuration mode, with red LED flashing.
• Exit configuration mode
Two short beeps, low - high tone. Setup label read successfully.
One short beep, high tone.
• More setup label: required.
• Input PIN code.
• Clear PIN code.
One short beep, low tone. More barcodes required to complete the “output
sequence” requirements of Multi-Barcode Editor, with
green LED on and off quickly (upon completion, same
as good read).
One long beep, low tone.
• Transmit buffer full, with red LED on and off
quickly.
• Transmit buffer disabled, with red LED on and off
quickly.
• Configuration error (Wrong label).
• PIN code input error.
• Reject random PIN request.
• Fail to send data in memory mode.
Two short beeps, high - low tone.
• Data saved to buffer when transmit buffer is
enabled and the scanner is out of range, with red
LED on and off quickly.
• Memory mode – memory full, with red LED on and
off quickly.
Two long beeps, high – low tone. Multi – Barcode mode – buffer full.
Three short beeps.
• Tone ascending from low to high.
• Bluetooth connection established, with blue LED
flashing.
• Bluetooth connection resumed, with blue LED
flashing.
Three short beeps.
• Tone ascending from high to low.
Bluetooth connection is out of range or suspended.