User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
21
Update
Chapter 1
Understanding the Barcode Scanner
Send Data
The 512 KB flash memory on the scanner can store up to 32,768 scans based on EAN-13
barcodes. When it is used up, the scanner will respond with two short beeps (high-low tone) as a
warning. You are advised to send data to the server immediately by having the scanner read the
label below.
Clear Data & Confirm
Even though data has been sent back to the server, the flash memory is still occupied unless you
erase the memory by having the scanner read two labels – “Clear Data” and “Confirm”.
1. Read the “Clear Data” label to clear the flash memory.
2. Read the “Confirm” label to confirm the action.
3 sec
5 sec
8 sec
S
end Data
Clear Data
Confirm