User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
17
Update
This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Battery..................................................................... 17
1.2 Memory.................................................................... 19
1.3 LE
D Indicator ............................................................ 22
1.4 Beeper
..................................................................... 24
1.5 Send
"NR" to Host .....................................................
28
1.6 Scan Modes .............................................................. 29
1.7 Scanner Ti
me-out ...................................................... 34
1.8 Del
ay between Re-read...............................................
35
1.9 Effective Decoding Area ..............................................
36
1.10 Auto-Sense Mode (1560 Only) .................................. 38
1.11 C
CD Sensor Always Active (1560 Only) ...................... 39
1.12 Negative Barcodes
................................................... 39
31.13 Symbologies Supported ............................................ 40
1.1 BATTERY
The scanner is powered by a rechargeable 3.7 V/800 mAh Li-ion battery, and it takes
approximately 3 hours to charge the battery to full (from the power adaptor). However,
the charging time may vary by working condition. For intensive data collection, you may
purchase a spare battery for non-stop operation.
Note: The scanner can be configured to save battery power. Refer to settings of “
Auto
Power Off”, “CCD Sensor Always Active”, “Sniff Mode”, as well as “Low Battery
Alarm”.
1.1.1 HOW TO OPERATE THE SCANNER
Turn on the scanner…
After installing the battery, hold down the trigger for about 2 seconds. The scanner will respond
with a long beep (high tone), and its LED will become solid red and go off quickly.
Turn off the scanner…
Remove the battery directly or let it turn off automatically in specific circumstances.
Chapter 1
UNDERSTANDING THE BARCODE SCANNER