User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
15
Update
Quick Start
LIST THE CURRENT SETTINGS
The current settings of all scanner parameters can be sent to the host computer for user
inspection. The listing includes ten pages as shown below. You can select the page of
interest by having the scanner read the “List Page x” label. The scanner will respond with
two beeps (low-high tone) and send the selected page to the host immediately.
List settings regarding Firmware Version,
Serial Number, Interface, Buzzer, and Other
Scanner Parameters
List settings regarding Prefix, Postfix, and
Length Code Setting
List settings regarding Code ID
List settings regarding: Readable
Symbologies
List settings regarding Symbology Parameters
(1/3)
List settings regarding Symbology Parameters
(2/3)
List settings regarding Symbology Parameters
(3/3)
List Page 1
List Page 2
List Page 3
List Page 4
List Page 5
List Page 6
List Page 7