User guide

8
Enter Setup
1500/1502 Barcode Scanner User Guide
The example below shows how to set numeric parameters:
Steps
Action User Feedback if Successful
1 Power on the scanner... The scanner will respond with a long beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
2 Enter the Configuration Mode…
T
he scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
Read a Setup label...
For example,
T
he scanner will respond with two beeps
(low-high tone) if reading a normal label.
3
T
he scanner will respond with one short
beep if reading a special label such as
“Max. Length”, indicating the setup
requires reading more labels.
Read the “Decimal Value” label(s).
 Refer to Appendix IV “Decimal
System”
T
he scanner will respond with two beeps
(low-high tone) when the input values are
validated.
4 Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
5 The scanner will automatically restart itself… Same as for Power on the scanner.
Normal label
Normal label
S
p
ecial label
Decimal label
or labels