User's Manual

Double click “SW3000006”. This will bring up a screen showing the available
services on this device.
After successful connection, the Bluetooth Device Driver will report the COM port
it mapped for this connection. In this case, it is COM3. You can also hear three
serial ascending tones from the scanner indicating successful connection.
After this initial connection, whenever an application program opens COM3, the
Bluetooth driver will automatically try to connect this particular scanner.
Click “OK”
We can see that there is only one service available on “SW3000006”. The service
name is “COM1 on SW3000006”, which is the Bluetooth Serial Port service.
Double click on the service. This will start the connecting process. Another
window might pop up and asking for PIN code, if Authentication (Secure
Connection) is enabled.
Right click the “COM1 on SW3000006” and select “Disconnect” to close the
connection. There will be three serial descending tones from the scanner to indicate
this condition.
After the connection is closed, the 1160/1260 and the Bluetooth driver are properly
configured and are ready to go. User can now run their application or “Hyper
Terminal” for testing, and make the best use of this scanner.
20
19